Operation - PowerSmith PGT140 Manual Del Operador

STARTING AND STOPPING THE TRIMMER
To Start the Trimmer, press the lock-off button and squeeze the trigger switch.
To Stop the Trimmer, release the trigger switch.
Caution:
Always allow a few seconds for the cutting line spool to stop rotating after releasing the trigger
switch. Do not invert the trimmer/edger or place your hands under the guard until the trimmer/edger spool has come
to a complete stop.
CUTTING LINE AND FEEDING (FIG 9)
This trimmer uses .80" (2mm) diameter dual nylon line. During use, the tips of the cutting lines will become frayed and
worn. You may feed the cutting lines by either Auto-Feed or Manual-Feed.
Caution:
Do not bump trimmer on ground in attempt to feed line or for any other purposes.
Automatic Feeding the Cutting Line
When initially switching on the trimmer, a small length of line is fed
out. Each time the trimmer is started from the rest the line will advance
about 1/4".
You will hear a 'clattering' noise when the lines hit the line cutter (1). This
is normal. After a few seconds the line will be cut to the correct length
and the noise will reduce as the motor gains full speed. If the noise of
the line being cut can't be heard, more line will need to be fed out. To
feed more line, stop the trimmer completely; then restart, allowing the
motor to reach full speed. Repeat above until you hear the line hitting
against the line cutter.
Manually Feeding the Cutting Line
If required, the cutting line can be fed out manually.
1.
Turn off the trimmer and remove the battery.
2.
Press and release Manual Line Feed Button (3).
3.
Gently pull out the line.
4.
Repeat the step 2 and 3 until the cutting line is long enough to reach the Line Cutter.
NOTE:
If the line extends past the line cutter, too much line has been fed out. If too much line is fed out, remove the
spool cap (3) and turn spool counter-clockwise until the line is at the desired length.
TILTING THE MOTOR HEAD (FIG 10)
The motor head (3) on this trimmer can be tilted in 3 positions. 45° for
using on a flat cutting area, 30° for a sloped cutting area, and 0° for a
hard-to-reach area.
To Tilt the Motor Head:
1.
Press the tilt buttons (1) on the both sides of the motor head (3).
2.
Tilt the shaft (2) againt the motor head to the desired angle as shown
in Fig 10. A click sound indicates the shaft is locked in one of the
positions.
USING THE TRIMMER
Follow these tips when using the trimmer.
•
Hold the trimmer with your right hand on the rear handle and your left hand on the front handle.
•
keep a firm grip with both hands while in operation.
•
Trimmer should be held at a comfortable position with the rear handle about hip height.
English

OPERATION

10
2
1
3
FIG 9
2
FIG 10
1
3