HAMPTON BAY 51732 Guía De Uso Y Cuidado página 9

Assembly - Attaching the Fan Blades and Brackets
5
Attaching the blades to the blade
brackets
□
Attach a blade (E) to a blade bracket (D) by inserting the blade
attachment screws (AA) into the holes in the blade (E) and
through the blade bracket. The rubber washers are preattached
to the blade bracket.
□
Tighten each screw securely.
□
Repeat these steps for each blade (E) and blade bracket (D).
E
D
NOTE: Your fan blades are reversible. Select the blade side finish
which best accentuates your decor.
Assembly - Attaching the Light Kit Fitter Assembly
7
Attaching the light kit fitter assembly
IMPORTANT: It is critical to attach the light kit using
the quick connector. The fan will not operate unless
the light kit is connected to the fan.
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light kit.
□
Remove the three screws on the black bracket below the fan-
motor assembly (C).
□
Connect the wires from the light kit fitter assembly (F) to the
wires from the black bracket below the fan-motor assembly (C)
by connecting the molded adaptor plugs together.
□
Carefully tuck all wires and splices in the switch cup.
□
Position the switch cup of the light kit fitter assembly (F) on the
black bracket below the fan-motor assembly (C) and align the
three holes in the black bracket.
□
Re-install the three screws removed at the beginning of this
step to secure the light kit fitter assembly (F).
C
F
AA
6
Fastening the blade assemblies to
the motor
□
Fasten the blade assembly to the fan-motor assembly (C) by
inserting the alignment post into the slot on the bottom of the
motor and tightening the blade bracket (D) screws. The blade
bracket screws are pre-installed into the blade bracket (D).
□
Repeat this step for the remaining blade assemblies.
C
8
Installing the glass shades and
bulbs
WARNING: Allow the glass shades to cool completely before
removing.
CAUTION: Make sure the power is off before attaching or
removing the glass shades.
□
Insert the glass shade (G) into the glass holder by carefully
squeezing the steel tensioners on the light fixture socket together.
□
Gently slide the glass shade (G) over the steel tensioners. Make
sure the glass shade (G) is fully inserted into the socket for a
secure fit. Repeat these instructions for the remaining glass
shades.
□
With the power off, screw the light bulbs (H) into the light
sockets, Max. 9.5W.
□
Attach the pull chain extensions (DD) to the light pull chain and
the fan pull chain.
F
G
H
9
Please contact 1-855-HD-HAMPTON for further assistance.
B
D
DD
HAMPTONBAY.COM