Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installing Your Freezer
Unpacking Your Freezer
Remove all packaging material. This includes the foam base and all adhesive tape
holding the freezer accessories inside and
outside.
Inspect and remove any remains of packing, tape or printed materials before
powering on the freezer.
Adjusting Your Freezer
Your freezer is designed for freestanding installation only. It should not be recessed
or built-in.
Place the freezer on a floor strong enough to support it fully loaded.
When moving the freezer, never tilt it more than a 45-degree angle. This could
damage the compressor and the sealed system.
If the freezer is tilted let it stand in an upright position for at least 24 hours prior to
plugging. This is to allow the refrigerant to settle.
Proper Air Circulation
To assure your freezer works at the maximum efficiency it
was designed for, you should install it in a location where there is proper air
circulation, plumbing and electrical connections.
The following are recommended clearances around the freezer: Sides...............4"
(102mm)
Back..................4" (102mm)
Top....................Do not block
26
Publicidad
Tabla de contenido
