MZ electronic EV-020 Instrucciones De Uso página 26

Check menu
Use the (DOWN) or
Sensor Checks
The purpose of this function is to check the
state of the sensor:
contact open
contact closed
LCD Test
This function switches on all the display's
pixels thus making it possible to perform a
check on them.
Software Version
Indicates the version of the software installed.
Work Hours
Indicates the hours of operation of the winch.
Exit
To return to the settings menu.
Instrument calibration
Before using the instrument the following parameters must be set:
choice of unit of measurement (metres or feet);
•
detection of type of sensor (Standard or Project);
•
gipsy diameter setting (default value 33 cm) or reduction factor (default value 57).
•
EV-020
Tests
S e n s . C h e c k s
LCD Test
S w . V e r s i o n
W o r k H o u r s
E x i t
(UP) key to move around the parameters.
Select with
Confirm with
Select with
Confirm with
Confirm with
1 . 0 1
0
Sensor Test
Sensor Test
26
English
Rev. 11 – 2014