Reliable The EnviroMate BRIO Manual De Instrucciones página 14

INSTRUCTIONS FOR USE
FILLING THE bOILER TANK bEFORE USE
• Unscrew the boiler tank filler cap (M), and use the funnel (10) provided to
add two measures maximum (11) of water to the boiler tank (L) .
• Screw on the boiler tank filler cap (M).
• Fit the required tool (see the "ATTACHMENTS" paragraph) to the steam
handle (C).
SWITCHING ON
• Plug the appliance into a main socket and press the on/off switch (I); the red
light (G) will switch on .
• After a few minutes, the green light (H) will switch on to show that the steam
is ready, meaning that the tank is pressurised and that the appliance is ready
to dispense steam.
OPERATION
• The steam ready light (H) will switch on and off during operation to show that
the appliance has reached working pressure.
• To prevent the steam from being dispensed accidentally, the lock cursor (B)
must be moved from the left to the right ( ) ; to release the steam function,
move the cursor (B) from right to left ( ) .
• To dispense steam, press the button (A) on the gun (C).
• When using for the first time, it is a good idea to spray the steam jet into a
container to get rid of any water residues that might be inside the tube (any
water coming out is because of the condensed steam inside the tube). This
action needs to be repeated even after a few minutes of appliance inactivity.
In any case, when the gun begins to dispense steam, always point the jet
downwards to the ground.
IMPORTANT: When the appliance is not used, always block the steam release
button (A) using the steam ( )(B).
STEAM jET REGULATION
• Use the dial (K), to regulate the amount of steam dispensed, from a
minimum to a maximum, based on cleaning needs and on the type of
surface or upholstery being cleaned.
• Use a lower steam setting for delicate fabrics or surfaces.
10
2
3
1