Important.safety.warnings; Risk.of.electric.shockor.electrocution - Mi-T-M BIO-20R-0M10 Manual Del Usuario

WARNING:..When.using.this.product,.basic.precautions.should.always.be.observed,.including.the.following:
READ.ALL.SAFETY.WARNINGS.BEFORE.USING.BIOLOGICAL.RECYCLING..SYSTEM
HAZARD
RISK.OF.ELECTRIC.SHOCK.
OR.ELECTROCUTION
Operator's Manual

IMPORTANT.SAFETY.WARNINGS

POTENTIAL.CONSEQUENCE
Serious injury or death could occur
if the Biological Recycling System
is not properly grounded.
Biological Recycling
powered by electricity and may
cause electric shock or electrocution
if not installed properly.
Electrical shock may occur if
Biological Recycling System is not
operated properly.
Serious injury or death may occur if
electrical repairs are attempted by
unqualified persons.
Installation of this unit, including all electrical
connections, must comply with all local, state
and national codes.
Your
System is
This product must be grounded. Connect to a
GFCI circuit breaker when available. If the unit
should malfunction or breakdown, grounding
provides a path of least resistance for electric
current to reduce the risk of electric shock. Do
not ground to a gas supply line.
Improper connection of the equipment-
grounding conductor can result in a risk of
electrocution. Check with a qualified electrician
or service personnel if you are in doubt as to
whether the system is properly grounded.
Always be certain the unit is receiving proper
voltage (+/- 5% of the voltage listed on the
nameplate).
connections, be certain the power switches
are in the "OFF" position.
Keep all connections dry and off the ground.
Do not touch pump, pump motor, discharge
piping or water when the unit is connected to
the power supply; regardless of whether the
unit is operating correctly or experiencing an
operation failure.
DO NOT allow metal components of the
Biological Recycling System to come in contact
with live electrical components.
Never operate the Biological Recycling
System with safety guards/covers removed
or damaged. Ensure all electrical covers are
securely in place when unit is operating.
Any electrical wiring or repairs performed on this
Biological Recycling System should be done
by Authorized Service Personnel in accordance
with National and Local electrical codes.
Before opening any electrical enclosure, always
shut off the Biological Recycling System and
drain the water. Disconnect the Biological
Recycling System from the power source. If
the power disconnect is not in sight, lock it in
the open position and tag it to prevent power
usage. (Never assume the Biological Recycling
System is safe to work on just because it is not
operating, it could restart at any time! Always
disconnect from the power source.) Allow the
Biological Recycling System components to
cool down.
PREVENTION
Before installing electrical
5