Numark TTX Manual Del Usaurio página 9

Please read these precautionary notes to insure a complete understanding and long life of this DJ
turntable.
• Unnecessarily removing the platter may cause damage to the magnet mounting structure, the motor
or the platter resulting in undesired performance. The turntable should ALWAYS be powered off
before the turntable platter is removed for any reason.
• Unnecessarily "interchanging" tonearm tubes may cause premature wear to components of the
tonearm assembly or the tonearm tubes. Interchange tubes only on an "as needed" basis.
• Turning off the turntable while the output is set to LINE level or while the SPDIF output is in use will
result in an absence of audio. Keep this in mind during use - if the "motor off" effect is desired
effect, it is recommended that the BRAKE MOTOR CONTROL be adjusted.
• Do not attempt to adjust or tighten any tonearm components. Undesirable performance may be a
result of an improperly adjusted tonearm or worn cartridge.
• Never interchange tonearm tubes while the turntable is powered on.
• Any attempt to "customize" your turntable beyond interchanging the tonearm tubes is not
recommended and may result in PERMENANT DAMAGE to the turntable and/or a VOIDED
WARRANTY.
Turntable Section:
Motor: Direct Drive – 16 Pole, 3 phase
Start Time: 0-33.33 RPM in 0.2 seconds
Braking System: 9 Step Electronic Servo Brake
Platter: Dampened Aluminum Die-cast
Low Friction Design.
Speeds: 33.33, 45, and 78 RPM
Wow & Flutter: <0.15% WRMS (JIS C5521)
Digitally controlled by internal
quartz clock.
Pitch Range: ±8%, ±10%, ±20%, and ±50%
Rumble: -58dB (IEC 98A Unweighted)
-79dB (IEC 98A Weighted)
Torque: H : 4.7 kgfcm
constant torque : 3.7kgfcm
instant torque : 4.7 kgfcm
M : 3.7 kgfcm
constant torque : 2.7kgfcm
instant torque : 3.7 kgfcm
L : 2.5 kgfcm
constant torque : 1.1kgfcm
instant torque : 2.5 kgfcm
OTHER IMPORTANT NOTES
TTX Specifications
Tonearm Section:
Type:
Height Range:
Cue System:
Balance Weight:
General:
Dimensions:
Weight:
Power Consumption:
9
Locking collar based
interchangeable tube system. Die-
cast Aluminum
3-Bearing Construction
0.0 – 6.0 mm.
Dampened Lift Lever,
Arm Rest and Arm Clip
7.0 gram S-weight
75 gram Aluminum Plated
w/ 0.0 – 3.5 gram range scale
370mm(W) by 460mm(D) by
135mm(H)
27.7 lbs (12.6 kg)
65 Watts