ACDelco ARZ1205 Manual De Instrucciones página 15

VIDEO OUT PORT
Connect the Video Out Port to output what the camera is looking at into any displays.
Output Video format: NTSC
USING THE VISUAL INSPECTION CAMERA
1. Adjust the cable to best fit the opening.
2. After checking the workspace for hazards, insert the cable and adjust the zoom and
lighting as necessary.
3. Prepare the camera for inspection. The camera cable may need to be pre-formed or
bent to properly inspect the area. Do not try to form bends less than 2" radius. This
can damage cable. If inspecting a dark space, turn the LEDs on before inserting the
camera or cable.
4. Do not use excessive force to insert or withdraw the cable. This may result in
damage to the electrical device or inspection area. Do not use the cable or imager
head to modify surroundings, clear pathways or clogged areas, or as anything other
than an inspection device. This may result in damage to the electrical device or
inspection area. Do not insert the camera or cable into any space that will require less
than a 2" bend radius. Tight bends could damage the cable.
5. When the inspection is complete, carefully withdraw the camera and cable from the
inspection area.
WARNING
damage, always check the work area before beginning a job. Do not allow cable to
contact electrical, chemical, or moving hazards.
Behind Walls: Shut off circuit breakers to the entire area.
Inside Pipes: Ensure there is no electrical charge to the pipes before beginning
inspection. Do not allow liquid to flow down cable and into tool.
Auto Use: Turn off the engine and allow cooling before beginning inspection.
Do not allow the visual inspection camera or cable to contact oil, gas, or other
corrosive materials.
CAUTION
force or "kink" the cable. Do not use in areas where visual inspection camera and
cable will contact corrosive or oily substances. Do not use the cable to clear clogs or
move obstructions. This is not a drain cleaner!
1English1
To reduce the risk of explosion, electric shock and property
To reduce the risk of damage to the tool, do not use excessive
English -14