Descargar Imprimir esta página

ABC Design Amigo Instrucciones De Uso página 12

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
Customer complaints
• No claims may be made for natural wear and tear or for damage caused by undue demands on the product
or by exceeding the permissible load.
• No claims may be made for damage caused by improper use.
• No claims may be made for damage caused by incorrect assembly or operation.
• No claims may be made for damage caused by improper modifications to the product.
• Areas of rust may appear through lack of maintenance or improper care and do not constitute a fault with
the product.
• Scratch marks are normal signs of wear and do not constitute a fault with the product.
• Mildew is likely to appear on textiles which are not dried out after getting wet and cannot be attributed to
shortcomings in production conditions.
• The product may fade if exposed to sunlight, perspiration and detergents, or if subject to abrasion or
excessive washing, therefore fading cannot be attributed to a fault with the product.
• No claims may be made for wheels which become worn out as a natural result of wear and tear.
1. Opening the pushchair
Release the transportation lock.
Unfold the pushchair.
Use your foot to press the mechanism down which locks the pushchair into its open position.
CAUTION: Ensure that all the catches are engaged before use.
2. Fitting the wheels
a. Push the front wheels into the fittings until they click into place.
b. To remove the front wheels again, press the catches on the wheel fittings.
c. Push the rear wheel blocks into the fittings until they click into place.
d. Connect the snaps on both sides in order to attach the bar to the frame.
3. Using the brakes
Press the lever down to apply the brakes.
Press the lever up to release the brakes.
4. Adjusting the handles
To adjust the handle, press the catch under the handle down.
Turn the handle to the required position and let go of the catch again so that the handle clicks into the new
position.
5. Fastening the harness
To close the harness, push the clips (1) into the leg harness catch (2).
Adjust the strap to a setting where the baby is held in the correct position.
Caution: Always use the shoulder harness and lap belt together.
EN - 05

Publicidad

loading