Brentwood Appliances KT-1910BK Instrucciones De Operación Y Seguridad página 4

Before First Use
IMPORTANT: Please check all packaging material carefully before discarding as there may be
accessory parts contained within the packaging material.
WARNING: Do not place any part of the product in a dishwasher.
1. Fill the Kettle to the max level mark on the appliance with fresh tap water. Bring it to a boil.
2. Empty the water from the Kettle. Once cooled rinse Kettle with water.
3. Repeat process at least 2 times to ensure your Kettle is clean.
Attention: First use may cause a slight odor or small smoking upon heating, it is normal. This is a
result of the heating element chemical reaction. It quickly goes away.
Using Your Kettle:
1. Pull out the power cord from the base unit and connect it to a power outlet.
2. Open the lid then fill the water into the Kettle. CAUTION: Do not overfill the product or
operate it when empty.
3. Close the lid. Place the Kettle back onto the base unit. Making sure there is not water on
the bottom of the Kettle.
4. Turn the Kettle on by pushing the switch from "O" (off) to "I" (on). The Blue LED light inside
the Kettle should illuminate to indicate the Kettle is heating.
5. The Kettle will automatically switch off to the "O" position once the water has boiled. The
Blue LED light inside the Kettle will turn off.
Note: The switch only works when the Kettle body is correctly placed on base unit.
6. Lift the Kettle from the base using its handle and pour out your hot water into your
container.
Note: If you need to heat water again, let the appliance rest for 30-60 seconds before starting
again. **This will prolong the life of the Kettle.
7. When heating is complete, make sure the power switch is on the "O" position, and then
unplug the product from the electrical outlet.
WARNING: Always unplug the product from the electrical outlet when it is not in use or will
be left unattended.
Cleaning Your Kettle:
WARNING: Always unplug the product and allow it to cool before cleaning or storing it.
NOTICE: To avoid damaging the product, do not pour cold water into the Appliance after use
and do not use abrasive cleaners/pads to clean any part of the product.
• Make sure the Kettle is empty and has had time to cool before handling it.
• Do not run any other part of this appliance in the Dishwasher.
• Remove Kettle from base and clean with a nonabrasive cleaner and warm soapy water.
• Base should only be cleaned with a soft damp towel and dried before storing. DO NOT USE
RUNNING WATER.
• Dry all parts thoroughly before storing or using again.
4