Burda BRELGF1200 Serie Manual De Instalación página 8

Idiomas disponibles

4. Lock the bracket by tightening the 4 screws (M5*10mm):

5. Push the frame into the ceiling aperture, allowing metal springs to snap open. To secure the frame in position, push lower

ends of screws apart (Fig below). Ceiling board thickness should be adjusted to enable springs to be fitted without excessive

force.

6. After the assembly is completed, the spring clip is locked with 4 x M4*28mm screws on the left and right side, as shown in the

figure below.

Spring clip

The ceiling

Spring clip

Push spring

clip to secure

Cabinet