Burda SMART S IP24 Instrucciones De Montaje Y Uso página 5

NOTE: Key-hole slots, hocks and similar means,
without any further provision to prevent the heater
from being inadvertently lifted off the wall, are not
considered to be adequate means for fixing the
heater securely to the wall.
Compliance is checked by inspection.
The appliance should be fitted and connected by a
qualified electrician
P :
OWER CORD
• The power cord must not come into contact with
hot appliance parts!
• Never pull the plug out of the socket at the cord!
Never move the appliance by pulling at the cord or
use the cord for carrying purposes!
• Do not coil the cord around the appliance! Do not
use the appliance with the cord coiled!
• Do not crush the cord or drag it over sharp edges
or place it over heated hotplates or naked flames!
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard
I :
NSTALLATION
• The appliance should be fitted and connected by a
qualified electrician.
• Prior to starting any electrical work, the voltage
must be switched off to make sure that the wiring is
dead!
Only switch on the appliance when installation is
complete.
S
WITCHING ON FOR THE FIRST TIME
• After switching on the appliance for the first time
and following extended periods on non-use, the
appliance may smell for a short time.
C :
LEANING
• First, disconnect the equipment from the power
supply system!
• After the appliance has cooled down, the housing
can be wiped dry.
• Do not touch the quartz rods with your fingers,
since stains could build up from such a contact.
• The reflector should be cleaned regularly
• Do not use any abrasive or caustic cleaning agents!
• Never immerse the appliance in water! Danger to
life!
A -S S :
FTER ALES ERVICE
• All repairs must be referred to authorised
personnel! Therefore, you should contact your
specialized dealer or the customer service.
Important! Any tampering with the appliance will
invalidate the warranty.
• Repairs carried out improperly and by unqualified
persons may have serious consequences for the
user!
T :
ECHNICAL DATA
SMART S IP24 with switch 50/100%
Rated voltage: 230-240 V/50 Hz
Rated output: 1500W/2000W
Dimensions (LxWxD) 48x14,5x9,5cm
Weight about: 2,5 kg
Protective system: IP24
Appliances for wall mounting shall be constructed
so that they can be secured to a wall
GB
: