ShelterLogic Shed-in-a-Box 70333 Ensamble Manual página 7

Ocultar thumbs Ver también para Shed-in-a-Box 70333:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. sqUArinG Up tHe FrAMe
A. Place frame in its final location, which
needs to be as flat and level as possible.
B. Measure across opposite corners (X & Y).
These distances must be equal to within
1 inch.
C. Check that the front and rear of the frame
measures 10 feet in width.
6. properlY AncHor tHe FrAMe
WARNING: Serious injury to persons or property could result if cover is installed and
shelter is not anchored and is left unattended. Shelter MUST be securely anchored.
A. Anchors must be placed inside shelter at the corners of the shelter.
B. Insert a ¾ inch pipe or steel rod, through the eyelet of the auger and screw the anchor into the ground until
the eyelet is sticking out of the ground by 1 to 2 inches so it can be anchored to the legs.
If ground is too hard, dig a hole with a shovel or post hole tool. Optional: Fill with cement.
C. Wrap cable provided through the eyelet of the anchor and around the frame as shown below. Secure
the cable with the clamps provided.
10'
NOTE:
15" Augers are for temporary use only!
For best results ShelterLogic recom-
mends using our Easy Hooks (#10036
4-pack, #10035 6-pack, or #10038
8-pack) or 30" Augers (#10075 4-pack,
#10078 6-pack, or #10079 8-pack) for a
stronger, more secure installation.
End Rib Anchors
Page 7
10'
X
Y
Call 1-800-524-9970
or visit
www.shelterlogic.com
for more information.
WARNING:
Serious injury to persons
or property could result
if cover is installed and
shelter is not anchored and
is left unattended. Shelter
must be securely anchored
before use.
05_70333_70733_70734_70833_J1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Shed-in-a-box 70733Shed-in-a-box 70734Shed-in-a-box 70833

Tabla de contenido