Idylis 0416709 Manual De Instrucciones página 6

OPERATING INSTRUCTIONS
DEHUMIDIFIER:
Note: During dehumidifi er mode, the exhaust hose does not have to be vented outdoors.
1) Press the ON/OFF key pad to switch the unit on.
2) Press the MODE key until the DEHUMIDIFY indicator illuminates on the control
panel. Each press of the MODE key will advance to a different mode setting
(Cool-Dehumidifi er-Fan)
IMPORTANT: There is no temperature adjustment during dehumidifi er mode. If the room
temperature is greater than 77°F (26°C). The fan speed can be adjusted. Otherwise
the fan speed is fi xed at LOW speed.
INSTALLING DRAIN HOSE
IMPORTANT: The drain hose (Q) must be installed during dehumidifi er mode. The
continuous drain function can be set up using the following steps:
1) To save having to frequently empty the water tank, this unit
can be confi gured for continuous drain. You can use the
supplied drain hose (Q) to connect the continuous drain
connector.
2) Unscrew and remove the drain cover from the drain port at
the rear of the unit.
3) Remove the soft rubber stopper from the drain cover and
place it in the water tank for safe keeping.
4) Insert the drain hose (Q) through the hole of the drain cover.
5) Ensure the rubber seal ring is properly seated in the end of
the hose.
6) Connect the drain hose (Q) to the drain port.
7) Tighten the drain cover clockwise onto the rear of the unit.
8) Place the opposite end of the drain hose (Q) into a fl oor drain
or other basin.
Q
Bouchon en
caoutchouc souple
Capuchon de
vidange
Q
Q
Lowes.com
10
OPERATING INSTRUCTIONS
When using the continuous drain function, the drain hose must be placed horizontally below the
drainage hole. Avoid uneven ground and folding the hose. NOTE: Should you damage or misplace
the drain hose, a standard garden hose (not included) can be used as a replacement.
FAN MODE:
Note: During Fan Mode, the exhaust hose does not have to be vented outdoors.
1) Press the POWER SWITCH button to turn the unit on.
2) Press the MODE button until the FAN indicator illuminates on the control panel. Each
press of the MODE button will advance to a different mode setting (Cool-Dehumidifi er-
Fan)
3) Press the FAN button to select the desired FAN SPEED setting. Your selection will
appear on the control panel. Each press of the fan button will advance to a different
fan speed (Low-Medium-High.)
Lowes.com
11