OPERATING INSTRUCTIONS
AUTO-TIMER:
While the Air Conditioner is in Standby Mode (Auto-On):
1) Press the Timer button once and the adjacent Auto-Timer display will illuminate.
2) Use the Up/Down arrows to select a delayed On Time of up to 24 hours.
3) Select the appropriate mode under which you want the unit to operate (Cool-Dehumidify-
Fan.)
4) Select the fan speed setting.
5) The time you selected will appear in the LED display.
While the Air Conditioner is on (Auto-Off):
1) Press the Timer button and the adjacent Auto-Timer display will illuminate.
2) Use the Up/Down arrows to select a delayed Off Time of up to 24 hours.
3) Follow the steps 3, 4, and 5 the same as above.
Lowes.com
12
OPERATING INSTRUCTIONS
REMOTE CONTROL:
Control Buttons:
1) Power
2) Mode
3) Fan Speed
4) On/Off Timer
5) Time/Temperature Set
The timer setting is programmable from 1-24 hours by fi rst pressing the On/Off Timer button and then
the Time/Temperature Set buttons.
When either the
or
button is pressed in cool mode, the set temperature is displayed and may be
adjusted. After 15 seconds, the display will revert back to room temperature.
Two AAA Alkaline batteries (included) are required to operate the hand-held remote control.
Batteries should be replaced when:
a) No signal (beep) is heard when attempting to program the main unit using the remote.
b) The main unit does not respond to a command issued by the remote control.
Battery replacement:
1) Gently slide the rear cover on the remote in the direction of the arrow until it separates completely
from the unit.
2) Insert two Alkaline AAA batteries following the same orientation (polarity) depicted inside the battery
chamber (+/-).
3) Reinstall the rear cover.
4) If the remote control will not be used for extended periods of time, the batteries should be removed.
1
5
3
4
2
Lowes.com
13