Publicidad
1. The stone sink requires a stainless steel frame bracket # 5301-BR for installing on the wall.
Drill additional holes
to catch to existing
studs
2. In order to provide proper support for wall-mounting a stone sink, it's usually necessary to remove a small section of
drywall so you can access the wall studs and attach blocking between them.
3. Based on the sink's dimensions and mounting height, decide where support will be needed. Then remove
drywall in that area and install 2-by-6 or 2-by-8 blocking between the wall studs. Then using 3 1/2" galvanized
common nails, toenail the blocking to the studs and repair the drywall.
4. Attach the frame bracket to the wall by drilling min. three screws through the metal bracket directly into the studs
or reinforced wall.
LACAVA LLC
Installation Instructions
additional holes
to be drilled
along bar to
catch wall studs
22"
26"
24 7/8"
Required additional wall studs
at 22" spread to line
up with pre-drilled holes
in bracket and pre-drilled
22"
anchors in stone sink
3
10"
9 1/4"
Publicidad
