Monster SmartView 200M Guía Del Usuario Y Garantía página 14

Installing the Wall Plate
Masonry Mounting
While masonry materials (bolts and concrete anchors) are included, masonry
mounting requires specialized knowledge, skills and tools. Monster highly
recommends you seek the assistance of a professional installer when
mounting to masonry.
DO NOT drill holes in masonry mortar joints.
�����
1) With the help of a friend, position the wall plate in your desired
�����
mounting location. Level the wall plate with the provided bubble level.
Mark the centers of four bolt slots as shown to the right. Be careful not
to mark a mortar joint.
2)
With your electrical drill and 1/2" masonry bit, pre-drill a 3" deep hole
at each mark.
3)
Install the supplied plastic concrete anchors in each hole. Tap into hole
until fully seated.
4)
Attach the wall plate to the wall using the lag bolts and round washers
as shown to the right. Make sure fl at center of the plate is facing the wall.
DO NOT over tighten bolts. This can damage the wall plate
or your wall surface.
DO NOT release the wall plate until you are absolutely certain
it is secured to the wall.
10
continued