Plumbing Connections - Seko KOMPACT AMC Serie Manual De Instalación

DOSING MODE SETTINGS

PLUMBING CONNECTIONS

2
4
6
6
4
8
11
4
6
6
4
13
After around 800 hours of work, tighten the bolts on the pump body, applying a tightening torque of 3 Nm.
When making the plumbing connections, make sure that you follow the instructions below:
- BOTTOM FILTER
The
prevent any formation of deposits.
- Installation of the pump suction head is
products which develop gas (e.g. sodium hypochlorite, hydrazine, hydrogen peroxide, etc.).
- If you need to use longer hoses than those provided in the installation kit, it is important that you use hoses of the same
dimensions as those supplied with the pump. If the DELIVERY HOSE may be exposed to the sunʼs rays, we recommend
using a black hose able to withstand ultraviolet rays
- It is advisable to position the
- INJECTION VALVE, supplied with the pump, must always be installed at the end of the delivery line on of the dosing
The
flow.
EM00136225
A switch (shown in the figure) that regulates the dosing mode of the pump
is present in the part relative to the electrical connections on the circuit.
The two different modes are:
Constant (switch in position C)
The pump constantly dispenses the percentage selected with a
potentiometer.
Proportional (switch in position P)
The pump doses proportionally to the input signal (Pulse emission meter).
1
3
5
7
5
9
10
14
5
12
5
3
Fixing templates wall bracket
must be installed so that it is always positioned 5-10 cm from the bottom, in order to
recommended for pumps with very low flow rates.
INJECTION POINT higher than the pump or tank.
1. Injection point
2. Injection fitting
3. Seal
4. Pipe holder
5. Pipe clamp
6. Ring nut
7. Delivery hose (rigid)
8. Delivery valve
9. Pump body
10. Bleed valve
11. Suction valve
12. Suction hose (soft)
13. Bottom filter
14. Bleed valve connector
rev.1.0 EN
In particular, when dosing
3