Decorative Stitch - IKEA AA-516805-6 Manual De Instrucciones

Decorative stitch

Choose the decorative stitch by turning stitch selector dial to either G, H, I
or J. The thread tension should be from 6-8. Make sure the presser foot is
properly attached (page 21).
1. Move the needle upwards by turning the hand wheel towards you. Lift
up the presser foot and feed the fabric underneath. Turn the hand
wheel towards you to move the needle down to the place on the fabric
where you want to start sewing. Lower the presser foot. Make sure
that the top thread and bobbin thread are pulled towards the back of
the machine under the presser foot.
2. Press the foot control carefully and start sewing.
3. If you want to change direction, at a corner for example, leave the
needle in the fabric. Then lift the presser foot and turn the fabric round
the needle. Lower the presser foot and continue sewing.
4. When you have finished, lift the fabric and pull it about 15 cm
backwards. Cut the threads with the thread cutter, leaving them the
right length for when you start sewing the next seam.
TIP! Try sewing on a scrap of fabric first to adjust any settings if
necessary before using the "proper" fabric.
Foot Stich
1
3
Thread
tension
2
4
ENGLISH
17