NuTone PUREPOWER Serie Guia De Instalacion página 21

CI377W CANSWEEP

Choose a desired
position on the baseboard
between two studs.
Place the template (cut
from this instruction sheet)
on the position, and trace
the outline of the area.

Trim the opening on
the baseboard and
through the drywall
until reaching the
2" x 4" bottom wall
plate.

Against the edge of the
2" x 4" bottom plate, mark the
center of the opening.

Reference Hole
Drill a small reference hole
at the mark through the subfloor to below.
Locate the reference hole from below
and measure back 1 7 /
to remove the 2"x4" bottom plate
section behind the opening.
® BASEBOARD WALL INSTALLATION
T e m
p l a
t e
2" x 4" Bottom Plate
Mark Center
2" x 4"
Bottom Plate
Reference
Hole
1⅞"
" . Use a 2" hole saw
8

Make piping
connections as
required and
ready the short
90° elbow in position
behind the CanSweep
Make sure that the opening of the elbow will securely
attach onto the spigot on the back of the CanSweep
when it is time for connection.
Slide the low volt wires into the CanSweep
as shown to complete the wiring connections.

Slide the
CanSweep ® and
low voltage wires
into the opening
on the
baseboard.
Friction fit the
®
CanSweep
spigot into the elbow. Secure the CanSweep
baseboard with the 2 supplied screws.
21
Do not glue
CanSweep
the elbow.
Attach wires
®
.
® clips
® to the
®
to
®