Wall Inlet Installation - NuTone PUREPOWER Serie Guia De Instalacion

INSTALLATION IN NEW CONSTRUCTION (

WALL INLET INSTALLATION

MODEL 360 W I
ALL NLET
(CF361 CF361F R
AND
B
Remove the cardboard plaster guard.
C Refer to figure at
For some drywall or panel
construction, the plaster frame
will extend beyond the finished
wall. In this case, remove
plaster frame from mounting
bracket by removing mounting
screws.
NOTE: When using the model CF361 and CF361F inlet
bracket on walls thinner than 1⁄2", use a 1⁄4" spacer
(not furnished) between the wall and the inlet bracket.
See figure below. Spacer may be made from plywood,
Masonite™, etc. Contact cement may be used to hold
spacer in place during assembly. Configuration of
spacer may vary depending upon installation.
INLET MOUNTING
1/4"
BRACKET
3
1
2 / "
4
AD0057A
D Refer to figure at right.
Connect 2-conductor low-
voltage wire to terminal
screws on back of wall inlet.
E Guide excess wire back through the hole in inlet bracket and
flanged fitting.
F Refer to figure at right. Place
inlet into mounting bracket and
secure.
- )
OUGH INS
right.
AR0045
SPACER
WALL LESS THAN
1
/ " THICK.
2
1
PLASTER
/ "
4
GUARD
HOLE
AE0040
INLET
AE0024A
MODEL 330 W
B Refer to
2-conductor
to terminal screws on back of
wall inlet.
C Align inlet mounting holes with
holes in mounting plate.
D Refer to figure at right. Place
inlet into mounting plate and
secure with
screws.
MOUNTING
PLATE
9
' )
CONT D
I (CF329 R
ALL NLET
figure at right.
low-voltage
two provided
INLET
AE0024A
- )
OUGH IN
Connect
wire
MOUNTING
PLATE