Front Panel - Work Pro PA 200 MX Manual De Uso

FRONT PANEL

[POWER SWITCH
1.
Turn on/off the power.
Caution
·To ensure that high-volume noise is not output from the speakers, power on the connected device
first and then turn on this device. When turning the system off, turn off this device, and then the
connected devices.
·After turning the power switch off, wait for about five seconds before turning it on again. Rapidly
turning the power switch on and off in succession can cause the unit to malfunction.
·Even when the switch is in the off position, a small amount of electricity is still flowing to the unit.
If it will not be used for an extended period of time, therefore, be sure to unplug the power cord
from the wall AC outlet.
[POWER ]
indicator
2.
Turns on when the power is on.
[VOLUME LIMIT] indicator
4.
Lits if signal output to the speakers exceeds
the limit value, causing the limiter to activate,
or if the internal temperature of the device
tincreases abnormally. If the limiter activates,
turn the [VOLUME] knob to the left so
the indicator light goes out.
[VOLUME]
knob
5.
Adjusts the master volume output to the speakers. Turning to the right the volume increases.
Turning all the way to the left mutes the sound.
[TREBLE]
6. knob
Adjusts the high frequencies tone in the output. Turning to the right the tone gain increases.
Turning all the way to the left reduces it.
[BASS]
knob
7.
Adjusts the low frequencies tone in the output. Turning to the right increases the tone gain.
Turning all the way to the left reduces it.
[INPUT]
selector
8.
It allows to select the LINE input. INPUT 1 in the front side and INPUT 2 & 3 in the rear panel.
When the device detects signal, the corresponding green LED will lit.
[INPUT 1]
9.
This stereo minijack connector corresponds to INPUT 1. It accept LINE level. NOTE: Without
insert LINE input connector, the Bluetooth function is actived. When you insert a connector,
the Bluetooth function is disabled and operate the LINE input.
[LEVEL]
knob
10.
Adjusts the selected LINE input volume. Turning to the right the level increases.
Turning all the way to the left mutes the sound.
11.
[MIC INPUT SIGNAL]
It lits when a signal is connected in the mic input terminals placed in the rear panel.
11
10
]
]
indicator
3
9
8 7 6
3.
[VOLUME SIGNAL]
Lits when input signal exceeds a
certain level.
Low-impedance
connections
[16Ω]
[70V]
High-impedance
connections
[100V]
User Manual / Manual de uso
3
2
5 4 1
indicator
[VOLUME SIGNAL]
[8Ω]
-17.0dBu or more
-17.0dBu or more
-0.8dBu or more
2.3dBu or more
PA 200 MX
EN