Hotpoint Ariston HHBS 9.8C LTD K Instrucciones De Uso página 21

ELECTRICAL CONNECTION
The mains power supply must correspond to the rating indicated on the plate
situated inside the hood. If provided with a plug connect the hood to a socket in
compliance with current regulations and positioned in an accessible area, after
installation. If it not fitted with a plug (direct mains connection) or if the plug is not
located in an accessible area, after installation, apply a double pole switch in
accordance with standards which assures the complete disconnection of the
mains under conditions relating to over-current category III, in accordance with
installation instructions.
Warning! Before re-connecting the hood circuit to the mains supply and
checking the efficient function, always check that the mains cable is correctly
assembled.
Replacing the power cable
The hood is provided with a special power cable ; if the cable is damaged,
request a new one from Technical Service.
FILTERING OR DUCTING ?
! Your cooker hood is designed to be used only in filtering version
The filtering system provides a High Performance activated charcoal filter
Note: due to its technical characteristics, it is not possible to use the hood in
the extraction mode
Important! To proceed with the installation it is necessary to use a tube of
flexible type
Filter version
The aspirated air will be degreased and deodorised before being fed back into
the room.
In order to use the hood in this version, you have to install a system of additional
filtering based on activated charcoal.
21