Installation - Sony XAV-W650BT Manual De Instrucciones

Using the wired remote control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1 (not
supplied) is required before use.
1
To enable the steering wheel remote control, select
[General Settings]  [User Defined] to make the
registration (page 19).
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable RC-SR1 (not
supplied)
 Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper connection
may damage the unit.
 Consulting the dealer or an experienced technician
for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [Steering
Control] in [General Settings] to [Preset] (page 19).
Using the rearview camera
Installation of the rearview camera (not supplied) is
required before use.
The image of a rearview camera connected to the
CAMERA IN terminal is displayed when:
 the back lamp of your car lights up (or the shift
lever is set to the R (reverse) position).
 you press HOME, then touch [Rear Camera].
 you press and hold DSPL then touch [Rear
Camera] if [SOURCE Key Func.] is set to [DSPL]
(page 19).
36
GB

Installation

Removing the bracket
Before installing the unit, remove the bracket 
from the unit.
1
Insert the release keys  into the
catches between the unit and the
bracket  at the same time until they
click.


Catch
2
Pull down the bracket , then pull up
the unit to separate them.
Face the hook inwards.