HEINE mini 3000 Clip Lamp Instrucciones De Uso página 36

The device is intended for use in the electromagnetic environment specified below. The customer or
the user of the device should assure that it is used in such environments.
Statement for the operational
environments
Performance features of the
ME system that have been
determined to be essential to
the performance
Warning
A list of all cables, transducers
and other accessories that are
relevant for the EMC compliance
Test
RF emissions CISPR11
Harmonic Emissions
Voltage Fluctuations/Flicker
*n/a: „Not applicable" in the internally powered mode
36/44
Electromagnetic disturbances – Requirements and tests
Inside hospitals except for: near active HF surgical equipment
and the RF shielded room of an ME system for magnetic reso-
nance imaging, where the intensity of EM disturbances are high.
Use of this equipment adjacent to or stacked with other equip-
ment should be avoided because it could result in improper
operation. If such use is necessary, this equipment and the
other equipment should be observed to verify that they are
operating normally.
Use of accessories, transducers and cables other than those
specified or provided by the manufacturer of this equipment
could result in increased electromagnetic emissions or decre-
ased electromagnetic immunity of this equipment and result in
improper operation.
Portable RF communications equipment (including peripherals
such as antenna cables and external antennas) should be
used no closer than 30 cm (12 inches) to any part of the
mini 3000 Cliplamp, including cables specified by the manu-
facturer. Otherwise, degradation of the performance of this
equipment could result.
MED 0811
None
See attachment
Compliance
Group 1
Class B
Passed*
Passed*
2020-08-18