LG STYLER S3RERB El Manual Del Propietario página 41

Ocultar thumbs Ver también para STYLER S3RERB:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
Problem
Control panel won't
respond
The cycle won't start
Performance
Problem
Clothes are wet at the
end of the cycle
Odor is not removed at
end of cycle
Wrinkles are not
removed at end of
cycle
Clothes have an
unpleasant odor at end
of cycle
Functions are not
operating properly
Possible Cause
Control panel or button has
dirt on it
Control panel is locked
Start/Pause was not touched
after the cycle was set.
Cycle is producing steam
Control panel is locked
Possible Cause
Filter is clogged or grill is
upside down
Door gasket is damaged
Clothes caught in door
Clothes were stored for a
long period of time or are
stained with a strong-smelling
substance
Clothes were stored for a long
period of time
Appliance has not been used
for a long time or water tanks
and filters have not been
cleaned
Detergent or fabric softener
put in water supply tank
Solutions
Dirt or foreign objects on the control panel
will interfere with the operation of the
buttons. Clean the control panel.
Disable the Control Lock function. See
Locking the Controls, page 34.
Touch Start.
There may be a period of inactivity while
steam is produced.
Disable the Control Lock function and
touch Start. See Locking the Controls,
page 34.
Solutions
Clean the lint filter. Insert the grill with the
holes on the right side.
If the rubber door gasket is damaged, it
leaves a gap in the door seal, affecting
performance of the appliance. Call for
service.
Make sure all items are completely in
the cabinet and not stuck in the door,
blocking it from closing completely. Run
the cycle again.
Odors can be particularly difficult to
remove from clothes that have been
stored for long periods or have strong-
smelling, oily stains. Wash the clothes
first, before using the Styler.
Wrinkles may be very difficult to remove
if set for a long time, especially in cotton
and linen fabrics. Iron clothes that have
been stored for a long period of time
before treating them with the Styler, to
remove wrinkles more effectively.
Check for dirt or foreign objects in the
water supply and water drain tanks. Clean
the filters and water tanks.
Do not use anything but clean water in
the water supply tank.
MAINTENANCE
41

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido