Hitachi CP-X2514WN Manual De Usuario página 202

Network Bridge Communication
This projector is equipped with NETWORK BRIDGE function.
When the projector connects to the computer by wired or wireles LAN
communicaton, an external device that is connected with this projector by RS-
232C communication can be controlled from the computer as a network terminal.
For details, see the 6. Network Bridge function in the Network Guide.
NOTE • If data is transferred via wireless and wired LAN at the same time,
the projector may not be able to process the data correctly.
Connection
If you use wired LAN, connect the computer's LAN port and the projector's LAN
1.
port with a LAN cable. Use the cable that fulfills the specification shown in figure.
If you use wireless LAN, insert the USB wireless adapter into the projector's LAN port.
Connect the projector's CONTROL port and the RS-232C port of the devices
2.
that you want to control with a RS-232C cable.
Turn the computer on, and after the computer has started up turn the
3.
projector on.
Set the COMMUNICATION TYPE to NETWORK BRIDGE. (
4.
- SERVICE - COMMUNICATION in the Operating Guide)
LAN
LAN cable
(CAT-5 or greater)
LAN
CONTROL
Network Bridge Communication
RS-232C
OPTION menu
15