Hilti SJD 6-A22 Manual Del Usuario página 25

Status
1 LED lights.
1 LED blinks.
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the battery charge state LEDs blink, please refer to the information
given in the Troubleshooting section.
3.5 Dust blower
The dust blower directs a jet of air toward the saw blade in order to keep the cutting line free of dust.
3.6 Stroke rate
The stroke rate can be adjusted by turning the thumbwheel. Position 1 corresponds to 800 strokes per
minute and position 6 corresponds to 3000 strokes per minute.
Depending on how far the on/off switch is pressed, the stroke rate begins at 75 strokes per minute and
increases to the stroke rate set by the thumbwheel.
3.7 4 orbital-action settings
The 4 orbital-action settings allow cutting performance and quality of cut to be adjusted to suit the material
to be cut. The orbital-action adjustment lever is used to set the power tool to one of the 4 settings.
The lower the orbital-action setting, the finer and cleaner the cut edges will be. The optimum setting can be
determined by carrying out practical tests.
Status
Position 0
Position 1
Position 2
Position 3
3.8 Lockbutton 2
The lockbutton has three positions.
• The middle position is the normal position: The lockbutton can be seen on the left and on the right. In
this position, for example, the stroke rate can be adjusted.
The on/off switch can be pressed and released.
• The lockbutton can be seen only on the left: Transport position (the tool cannot start)
The on/off switch is locked and cannot be pressed.
• The lockbutton can be seen only on the right: After the tool has been switched on (on/off switch fully
pressed), the lockbutton can be pushed to the right to lock the switch in the "on" position. To release the
lock, press the on/off button again.
3.9 Anti-splinter insert
The product can be equipped with an anti-splinter insert.
The anti-splinter insert helps prevent splintering on the surface of wood materials when cutting.
3.10 Automatic switch-off
If the on/off switch is pressed continuously for longer than 15 minutes (e.g. during transport or storage), the
tool switches itself off automatically. This prevents deep discharge of the battery.
3.11 SJD DRS-6A dust removal module (accessory)
The SJD DRS­6A dust removal module is an accessory for the Hilti SJD 6-A22 orbital-action jig saw.
It collects a high percentage of the dust generated and can be quickly and easily attached to the orbital-
action jig saw. The dust removal module is equipped with a suction fan. This fan is driven by its own motor.
When the orbital-action jig saw is switched on the dust removal module draws its electric power from the
power tool's battery. The dust removal module is not suitable for working on materials containing asbestos,
*2149486*
Meaning
Charge state: 10 % to 25 %
Charge state: < 10 %
Meaning
No orbital action
Low orbital action
Medium orbital action
High orbital action
2149486 English 19