Aquaglide QUARTERBACK Manual Del Usuario página 6

Inflatable Products – Aquaglide makes some of the highest quality inflatable products in
the world. With proper care and maintenance, our products are expected to last for years
under normal use. We list important tips and instructions below. If unsure about any point,
please reach us through our website at Aquaglide.com/contact-us.
Note: see Anchoring instructions (below) before inflating this item. Strong winds can make it
difficult to control this product. Be aware of weather conditions before installation.
Air Pump - Use an air pump recommended for inflating your product. For products this
size, use of a high-volume electrical pump is best. Air pressure requirements are low
– 5.0psi (0,35bar) or less. Air compressors designed for high-pressure inflation are not
recommended because they can easily lead to over-inflation.
Valve(s) – This product uses Halkey Roberts – type (HR) valves. Valve
attaches to product using a threaded backing plate, making it easily
replaceable in the unlikely event of damage.
Access valve using a coin or flat tool to twist the tamper-resistant
cap counter-clockwise. To close, insert the cap and twist clockwise
using the same tool. Note: cap is the secondary air seal. See A.
To inflate, an air pump with Halkey Roberts – type
(HR) valve fitting is required. Insert fitting into valve
and twist clockwise to lock in place. See B.
Valve Operation: To operate Halkey Roberts
– type (HR) valve, press plunger and turn 90
degrees to set valve for inflate and product use
(plunger out = 1-way airflow). Press plunger and
turn 90 degrees to deflate (plunger in = 2-way
airflow). Note: valve is primary air seal. After
inflation, close with cap for secondary seal. See C.
Pressure Release Valve: Product is fitted
with a pressure release valve (PRV) in critical
chamber(s) to help provide catastrophic protection
against damage caused by over-inflation. It is still
necessary to check and regulate air pressure to maintain proper
working pressure levels. PRV has a unique setting specified to
release above, and to close near working pressure. PRV attaches
to product using a threaded backing plate, making it easily
serviceable. See D.
Proper Working Pressure for each chamber is listed below. Do
not overfill or underfill. Excessive pressure can cause damage to the product and may void
the warranty. Do not use without adequate air pressure. Product can become unstable if
underfilled and may not support indicated capacity. Use a pressure gauge (manometer) to
carefully monitor air pressure in the product especially during hot or cool periods.
Chart 1 – Working Pressure by Chamber - Quarterback
Valve [Inflate Order]
MAIN [1]
6
ASSEMBLY
Working Pressure in psi (Bar)
1.0psi (0,069bar)
A
B
C
Inflate (1-way)
D
www.aquaglide.com
Deflate (2-way)