Glacier bay HD67495-1008D2 Guía De Instalación Y Cuidado página 15

Troubleshooting (continued)
3
The sensor is not activating
the water flow
□
When you turn the handle to the full on position,
the water will turn on.
□
However, when you move your hand in front
of the sensor, the water does not turn off as
it should.
□
This indicates that the control box is damaged.
Call Glacier Bay customer service to request
a replacement control box. Replace the old
control box with the new control box.
H
4
There is a low flow of water
□
This could indicate that the washer in the
"in" end of the control box is dirty or damaged.
Remove the hose and unscrew the connector.
Take out the washer from the control box. Clear
the washer or replace the washer. Reassemble
the connector and hose.
Hose
□
Or the screen lter in the spray head is dirty. Turn
off the water supply at angle stop and unscrew
the spray head from spray hose. Clean the screen
lter in the spray head under running water.
15
Please contact 1-855-HD-GLACIER for further assistance.
Connector
Washer
Control
box
Screen lter
HOMEDEPOT.COM/GLACIERBAY