Troubleshooting - Southland SFTT140 Manual De Operación

Troubleshooting

• Save all instructions
PROBLEM
Engine difficult to start
Engine Problems
Engine smokes excessively
Engine runs very "rough"
Engine runs erratically
Engine cannot maintain full speed
Excessive vibration / noise
Tines will not rotate
Tines continue to rotate when
lever is not engaged
Engine will not stop
Tines will not cut properly
Frequent engine stalling
Questions? Call Toll Free at 1-800-737-2112
POSSIBLE CAUSE(S)
1. Out of fuel
2. Engine Switch Off
3. Engine is not primed
4. Spark plug wire disconnected
5. Fouled spark plug
6. Dirty Carburetor
7. Clogged air filter
8. Contaminated Fuel
1. No Engine Oil
2. Engine oil not at proper level
3. Fouled spark plug
4. Clogged air filter
5. Contaminated Fuel
6. Carburetor out of adjustment
1. Loose parts
2. Engine problems (above)
1. Debris interfering with tines
2. Tines loose
3. Improper drive cable adjustment
4. Damaged drive belts
1. Improper drive cable adjustment
2. Damaged drive belts
Faulty switch
1. Damaged or worn tines
2. Tines assembled incorrectly
1. Excessive tilling speed / depth
2. Engine problems (above)
18
SOLUTION(S)
1. Add fresh fuel
2. Turn engine switch on
3. Push primer 3 times.
4. Attach spark plug wire to spark plug
5. Remove spark plug. Inspect. Replace if
necessary
6. Take unit to an authorized service center
for Carburetor cleaning
7. Remove and clean air filter
8. Drain fuel tank. Clean fuel tank. Fill with
fresh fuel
1. Add engine oil
2. Check engine oil. Add or drain engine oil if
necessary
3. Remove spark plug. Inspect. Replace if
necessary
4. Remove and clean air filter
5. Drain fuel tank. Clean fuel tank. Fill with
fresh fuel
6. Take unit to an authorized service center
for Carburetor adjustment
1. Tighten all fasteners
2. Refer to engine solutions (above)
1. Remove debris from around tines
2. Replace tine bolts and nuts
3. Refer to "Belt Tension Adjustment" Section
to decrease belt tension
4. Replace drive belts
1. Refer to "Belt Tension Adjustment" Section
to decrease belt tension
2. Replace drive belts
Replace switch
1. Replace tines
2. Refer to "Install the Tines" Section
1. Till at a moderate pace. Make multiple
passes.
2. Refer to engine solutions (above)
Copyright © 2015 MAT Engine Technologies, LLC