Denon Professional DN-106S Guia Del Usuario página 4

Speaker Diagram
Top View
Attachment Screws
Rear View
Installation
To ensure a reliable installation, please follow these steps carefully:
1. Assemble the speaker mounting bracket (see graphic below) by taking one of the alignment beams
and sticking it under the groove in the "C" shaped speaker mounting bracket. Place in the desired
install location and use 2 screws and 2 washers to connect. Repeat this process on the other side
while making sure the holes line up evenly.
2. Determine the speaker position, taking into account any obstructions in the ceiling space. Note that a
clearance of 173 mm above the lower face of the ceiling is required. The cutout diameter is 222 mm.
3. Remove the ceiling space and position the "C" shaped speaker mounting bracket so that it fits the
hole that you cut. Use a metal safety wire with a snap hook (sold separately) and loop it around a
truss/beam on one end. Use a screw to mount the safety wire by fastening the speaker mounting
bracket into the truss/beam that the safety wire is looped around. Make sure the screw head covers
the surface area of the screw hole.
4. Remove the supplied 4-pin Euroblock from the speaker and connect it to the speaker cable (see
graphic below).
4
Rotating Mounting
Tab
Euroblock
Loudspeaker Driver
Tap Selector
Steel Backcan
Safety Hook
Rotating Mounting Tabs