Setting The Angle Of The Wall-Mount Brackets - Sharp AN-52AG2 Manual De Manejo

Setting the Angle of the Wall-mount Brackets

The wall-mount brackets are preassembled in the vertical (0
packed, so the following procedure must be used to install the TV at an angle.
(5 angles are possible: 0
Remove the angle holding screws.
1
Remove the 2 angle holding screws (M5, 8mm length). These 2 screws are used to set the
angle (Step 4). Put the screws in a safe place so as not to lose them.
Open the wall-mount brackets
2
Loosen the angle setting screws and nuts and then open the wall-mount brackets in the
direction shown by the arrows.
Angle setting screw
° ° ° ° °
, 5 , 10 , 15 , 20 )
°
) position setting when
Angle holding screw (black)
E-9