Proper Usage - Rola TX-104 Guía De Instrucciones

PROPER USAGE

INSTALLING ON VEHICLE
1. Slide shank end into receiver. FIG 2. Insert anti-rattle pin (H) with 5/8"
lock washer (D) and tighten securely with supplied wrench (J) then
install hitch pin (I).
2. Pull handle upward and remove. Rotate arms to the "up" position (until
holes in tube align). FIG 3.
3. Insert handle into the holes and push downward to secure. FIG 3.
3
Handle
FOLDING CARRIER FOR HATCH/TRUNK CLEARANCE
1. Securely hold main support tube (A) and remove bail pin.
FIG 4.
2. Lower the main support tube slowly until it is on the
collar bracket.
NOTE: Do not drop or let the main support tube fall freely.
Make sure that your hands and fingers are clear of the
hinging areas during this operation.
3. To restore the carrier to the upright position, reverse
procedure.
Align holes in tube
Push downward
to secure
PAGE 4
2
4
59401_IN_Rev A • Questions? (800) 234-6992 • RolaProducts.com
I
Remove Bail Pin
A
Main Support Tube
Receiver
H
D