Kohler PRO 3.7 Manual Del Usuario página 16

Install Wheelbarrow Handle Kit
Wheelbarrow Handle Kit
Wheelbarrow handle kit includes two
wheelbarrow handles and mounting hardware.
1. Align handle with holes on frame.
2. Place washers between handle and frame
while installing screw.
3. Thread nut to screw. Torque to 4 in. lb.
(0.5 N·m).
Install Cord Management Kit
Cord Kit
Cord management kit includes 2 posts and
mounting hardware. Cord management kit can
be installed anywhere on unit on same side, not
across unit.
1. Place post sides together onto frame.
2. Place 3 nuts into holes in 1 side.
3. While holding together, insert screws into
other side and thread into nuts. Torque to
221 in. lb. (25 N·m).
Install Lift Kit
Lifting Kit
16
NOTE: A clamping device or an assistant to
Lift kit includes lift bar and mounting hardware.
1. Align lift bar holes under holes of frame.
2. While holding in this position, install screws.
3. Thread nuts to screws. Torque to 221 in. lb.
(25 N·m).
Install Hand Truck Handle Kit
Hand Truck Handle Kit
NOTE: A clamping device or an assistant to
Hand truck handle kit includes hand truck
handle and mounting hardware.
1. Position hand truck handle on unit aligning
frame holes and handle holes.
2. Place washer between handle and frame.
3. While holding in this position, install screws.
4. Thread nuts to screws. Torque to 4 in. lb.
(0.5 N·m).
5. Install release knob through frame. Place
washer and hitch pin on inside of assembly.
Install Isolator Kit
Isolator Kit
Isolator Kit includes 4 isolators and mounting
hardware.
1. Align isolator holes under holes of frame.
2. While holding in this position, install screws.
3. Thread nuts to screws. Torque to 221 in. lb.
(25 N·m).
KohlerPower.com
hold assembly while installing kit will
make process easier.
hold assembly while installing kit will
make process easier.
37 590 01 Rev. J 8/18