Mx Onda MX-PI2624 Manual De Usuario E Instalacion página 69

The electrical connection of the induction hob must be carried out in
accordance with current regulations and protected by a single-pole
magnetothermic or automatic switch. The connection is shown below:
If the cable is damaged, to be substituted or replaced, the operation must
be carried out by an Official Mx Onda Technical Service.
If the induction hob is connected directly to the mains, a single-pole switch
must be installed with a minimum opening of 3 mm between the contacts.
The authorized installer must ensure that the correct electrical connection
has been made and that it complies with safety regulations.
The cable must not be bent or compressed.
The cable should be checked regularly and replaced only by authorized
technicians.
The yellow / green wire of the power cord must be connected to the earth
of the mains socket.
The manufacturer is not responsible for any accident resulting from the use
of an appliance that is not grounded or from faulty grounding continuity.
If the device has an electrical outlet, it must be installed so that the
electrical outlet is accessible.
21