Beper 70.096 Manual De Instrucciones página 9

Floor lamp Use instructions
USE ADVICE
In case of breakdown and/or bad use of the floor lamp, do not use the appliance,
turn off and do not manipulate it. For make it repaired, contact only the assistan­
ce centre authorized by the manufacturer and ask to use original spare parts. If
these rules are not respected that could compromise the security of the lamp and
void the warranty.
Always make sure that the voltage corresponds to the data specified on the label.
The cord supply does not obstruct circulation into the room.
To turn on and off the floor lamp use the button place on the feet of the floor lamp, do not
pull on the cord supply.
Do not leave the floor lamp on without supervision.
Place the floor lamp on a stand and horizontal surface.
Do not use the floor lamp near to heat sources, furniture, curtains or other objects.
Keep the lamp from a reasonable distance from objects that could be deformed by heat
of the floor lamp.
Do not use the floor lamp near to shower, bath, wash­hand basin or swimming pool.
Do never immerse the cord supply or the floor lamp into water or other liquids.
When using, the floor lamp is very hot; avoid contact with heating elements.
Keep away from children and pets.
Before cleaning or care, turn off the appliance and wait for the lamp is completely cooled
down.
When the floor lamp is not used for a long period it is recommended to store it in a dry and
cleaned place, as possible covered with a cloth to protect the lamp from dust.
Can not be used for commercial purpose.
The installation must be made according to the indications of the manufacturer. A bad
installation can cause damages to people, pets or objects, for those the manufacturer
cannot be responsible, and will void the warranty.
The floor lamp must be used only indoor.
Keep the floor lamp to at least 20 cm distance from the object .
HOW TO ASSEMBLY
1 – Insert the tube with the lamp head into the central tube and turn until complete locking.
2 – Insert the central tube into the lower tube and turn until complete locking.
3 – Insert completely the tube into the base and turn until complete locking.
4 – Screw the bulb, power max. 25 watt on E27 bulb holder.
USE INSTRUCTION
Place the floor lamp on a plane and stable surface.
Screw the bulb (not included), and connect the cord only after done it.
Lightly press the foot button to turn on the floor lamp.
Do not use bulb with power over 25W.
9