Remington RM2700 Manual Del Operador página 8

INSTALLING THE SHOULDER STRAP
WARNING:
To avoid serious personal injury, always use
the shoulder strap when operating the unit as a brushcutter.
1. Push the strap up through the center slot in the buckle (Fig. 4).
2. Bend the strap over and push it down through the lower slot in
the buckle (Fig. 4).
3. Put the shoulder strap over the operator's head and onto the left
shoulder.
4. Start the unit. Refer to Starting and Stopping.
5. Snap the clip onto the shoulder strap / harness loop (Fig. 5).
6. Adjust the shoulder strap to fit the operator (Fig. 6). Pull the
buckle up to loosen the shoulder strap. Pull the strap down to
tighten the shoulder strap.
Buckle
Strap
8
Clip
Lower Slot
Fig. 4
Clip
Shoulder Strap
/ Harness Loop
Fig. 5
Buckle
Strap
Fig. 6
Center
Slot