Descargar Imprimir esta página

Coleman POWER STEEL 90321 Manual De Instrucciones página 3

Piscina con estructura ronda

Publicidad

Idiomas disponibles

Idiomas disponibles

Thank you for buying a Coleman pool. In order to ensure that you gain maximum enjoyment and safe use of your pool please follow
the installation instructions in the DVD enclosed in your retail box along with the important safety guidelines in your owner's manual.
Assembly usually takes approximately 20 minutes with 2-3 people. (For 4.27 m x 1.07 m / 14' x 42'', 4.88 m x 1.22 m / 16' x 48" pools).
Assembly usually takes approximately 30 minutes with 2-3 people. (For 5.49 m x 1.22 m / 18' x 48", 6.71 m x 1.32 m /22' x 52'',
7.93 m x 1.32 m /26' x 52''pools).
Components list:
A
D
G
4
1
3
5
2
Ref#
Description
A
Top Rail
B
Vertical Pool Leg
C
T-Connector
D
Footing
E
Drain Valve cap
Hose Adaptor
F
Heavy Duty Repair Patch
G
Liner
H
Stopper Plug
I
Connection Valve
J
WARNING
Only for outdoor use.
Teach your children to swim.
Never dive, jump, or slide into the pool.
Adult supervision is always required.
Parents should learn CPR.
Never swim alone.
Keep all electrical radios, speakers and other appliances away from the swimming pool.
When you touch the filter, pump, or electrical parts, be sure the ground under your feet is "Bone Dry."
All electrical outlets should have a GFCI and connections should be a minimum of 5 feet (1.52 m) from the outside perimeter of
the wall of the pool. From 5–10 feet (1.52–3.05 m), there should be either a fixed connection (outlet box) or twistlock connection
with a GFCI.
Connect power cords to a 3-wire grounding-type outlet only.
Keep all breakable objects out of the pool area.
Alcohol consumption and pool activities do not mix. Never allow anyone to swim, dive or slide under the influence of alcohol or
drugs.
Severe electrical shock could result if you install
your pump or filter on a deck. The pump or filter
could fall into the water, causing severe shock or
electrocution. Do not install on a deck or other
surface at, above, or slightly below the top rail of
the pool.
Do not use the pool during severe weather
conditions, i.e. electrical storms, tornadoes, etc.
Be aware of overhead power lines when
vacuuming your pool or using a telescoping pole.
Do not allow diving, climbing, sitting, or standing
on the top rails of the pools.
Do not allow roughhousing and horseplay.
Do not engage in extended breath holding
activities underwater; you may black out and drown.
Install a pool ladder(s) or staircase for entry and
exit from the pool.
Keep deck clean and clear of objects that may
create a tripping hazard.
Check regularly for signs of wear or loose bolts that could make the deck unsafe.
Instruct pool users about the proper use of all pool ladder(s) and staircases.
Face ladder going up or down.
Allow only one person at a time on the ladder.
Check all nuts and bolts regularly to ensure that the ladder stays sturdy.
Remove or secure the ladder to prevent entry to pool when not in use.
Please contact pool site dealer or manufacturer for additional safety signs if deemed necessary.
For pool service, select a certified pool professional.
Any equipment connected to the circulation systems shall be positioned so as to prevent their being used as a means of access
to the pool by young children.
Installation must comply with the codes of the authority having jurisdiction and may require permits for buildings, plumbing
electrical, zoning, etc.
The pool shall be located a minimum distance of 6 ft (1.83 m) from any electrical receptacle.
All 125 volt, 15 and 20 ampere receptacles located within 20 ft (6.0 m) of the pool shall be protected by a ground fault circuit
interrupter (GFCI). The 20 ft (6 m) distance is measured via the shortest straight line distance the supply cord would follow
without piercing a floor, wall, ceiling, doorway, window, or other permanent barrier.
B
C
F
E
H
I
Pool Size & Part No.
J
P6H510
P6H723
8
7
6
Pool Size & Quantity
16
18
22
16
18
22
16
18
22
16
18
22
1
1
1
1
1
1
4
4
4
1
1
1
0
0
0
2
2
2
WARNING
PREVENT
NO DIVING!
DROWNING
Shallow water.
You can be permanently injured.
Watch children at all times.
The safety of your children depends entirely on you! Children under 5 years old are at greatest risk.
Please take care to avoid accidents.
Assign at least one person in charge of safety. Increase supervision if there are several people in the swimming pool.
Test the water temperature before entering the pool by splashing water on your neck, arms and legs.
Pool and accessories should only be assembled by competent adults.
Your pool should be filled by low-pressure water flow in order to prevent undue stress to the liner. Coleman will not be responsible
for damage to the pool due to filling via water truck (See FAQ's).
Toys, chairs, tables or similar objects that a young child could climb shall be at least 4 feet (1.22m) from the pool.
Store chemicals and accessories out of the reach of children.
Never add chemicals to pool while it is occupied. Consult a specialist pool supply retailer to ensure correct chemical usage.
Always keep the pool water clean.
Pool water should be tested regularly to ensure it is optimal for safe and enjoyable use throughout the season.
Household pets should be kept clear of pool area to avoid structural damage to pool.
A fence or barrier is necessary to provide protection against potential drowning and near drowning and ensure the gate is kept
closed at all times. The barriers are not a substitute for the constant supervision of children.
Cover the pool when it is not in use. Remove cover completely when in use.
Keep children away from pool covers to avoid entanglement, drowning or other serious injury.
A working electronic detector should be installed to alert you if someone has entered the pool area.
Under no circumstances should this equipment replace an adult's nearby supervision.
Only use Coleman accessories with Coleman pools.
Properly maintain your pool in order to increase life span and safe use (See Pool Maintenance Section).
Do not operate pump while pool is in use.
Prior to use of the pool, the installer shall affix all no diving signs and safety signs in accordance with installation instructions so
they can be easily visible.
All equipment should be inspected frequently for signs of deterioration, corrosion, broken parts or other hazards that may cause injury.
Remember to reapply sunscreen protection regularly and always after swimming.
Failure to follow these instructions can result in property damage, injury or death.
The installer of the vinyl liner shall affix on the original or replacement liner, or on the pool structure, all safety signs in accordance
with the manufacturer's instructions.
Description
If deck is used by the installer, it will need to comply with APSP-8.
1. Control valve
The swimming pool cover is not designated as a safety barrier.
2. O-ring
Please use artificial lighting during nighttime pool use, to illuminate all safety signs, ladders, steps, deck surfaces and walks.
3. Control Valve Gasket
Only persons older than 18 years of age can manipulate electrical accessories; they must conform to the appropriate safety
4. Connector Nut
principles of occupational safety and must be qualified to carry out the tasks on the electrical installation in accordance with any
5. Gasket
corresponding national regulations and standards.
Under no circumstances modify parts of the swimming pool. Do not make holes in the swimming pool, are in the steps of the ladder.
6. Connector
7. Debris Screen
SAFETY
8. Screw
Learn the necessary rescue operations, especially those relating to rescuing children.
Rescue equipment should be located near the pool and the supervising adult should be fully trained to use it.
Basic lifesaving equipment, including one of the following, shall be on hand at all times:
A. A light, strong, rigid pole (shepherd's crook) not less than 12 ft (3.66 m) long.
B. A minimum ¼ in. (6 mm) diameter rope as long as 1½ times the maximum width of the pool or 50 feet (15.24 m), whichever is
less, which has been firmly attached to a Coast Guard-approved ring buoy, or a similarly approved flotation devices.
A list of emergency telephone numbers shall be posted, such as the nearest available police, fire, ambulance, and/or rescue unit.
These numbers are to be kept near the telephone that is closest to the pool.
Publications are available that describe the risk of drowning, entrapment, and diving accidents. Available publications related to
pool safety include the Association of Pool and Spa Professionals' (APSP) booklets entitled: The Sensible Way to Enjoy Your
26
Aboveground/Onground Swimming Pool, Children Aren't Waterproof, Pool and Spa Emergency Procedures for Infants and
Children, Layers of Protection, and the latest published edition of ANSI/APSP-8 Model Barrier Code for Residential Swimming
26
Pools, Spas, and Hot Tubs.
26
In case of an accident:
26
• Take all the children out of the water immediately.
• Call for emergency support and follow their instruction/advice.
1
• Replace wet clothing with dry clothing.
1
For further safety tips check out the following websites:
www.homesafetycouncil.org
4
http://www.safety-council.org/info/child/water.html
1
0
RETAIN THESE DIRECTIONS FOR REFERENCE
2
CHOOSE THE CORRECT LOCATION
NOTE: The pool must be set up on a completely flat and level surface. Please do not install the pool if the surface is Inclined or slope.
Correct condition to set up the pool:
• The selected location has to be capable of uniformly supporting the weight for the entire time the pool is installed; moreover, the
location must be flat and must be cleared of all objects and debris including rocks and branches.
• We recommend positioning the pool away from any objects kids could use to climb into the pool.
NOTE: Position the pool near an adequate drainage system to deal with overflow or to discharge the pool.
NOTE: Position the pool near an AC power outlet protected by a GFCI (Ground Fault Circuit Interrupter).
Incorrect conditions to set up the pool:
• On uneven ground the pool may collapse causing serious personal injury and/or damage to personal property and will void the
warranty and prevent any service claims.
• Sand should not be used to create a level base; the ground must be dug out if necessary.
• Directly under overhead power lines or trees. Be sure the location does not contain underground utility pipes, lines or cables of
any kind.
• Do not set up the pool on driveways, decks, platforms, gravel or asphalt surfaces. The selected location should be firm enough
to withstand the pressure of the water; mud, sand, soft / loose soil or tar are not suitable.
• Grass or other vegetation under the pool will die and may cause odors and slime to develop, therefore we recommend removing
all grass from the selected pool location.
• Avoid areas prone to aggressive plant and weed species that may grow through the ground cloth or liner.
NOTE: Check with your local city council for by-laws relating to fencing, barriers, lighting and safety requirements and ensure
you comply with all laws.
NOTE: If have a filter pump, refer to the pump's manual for instructions.
NOTE: The ladder shall be located on a solid base and the ladder shall be installed per manufacturer's instructions. The ladder
must match the pool size and should to be used only for entering and exiting the pool. It is forbidden to exceed the permitted
payload of the ladder. Check regularly if the ladder is properly assembled.
Installation
Assembly of the Frame pool can be completed without tools.
Coleman will not be responsible for damage caused to the pool due to mishandling or failure to follow these instructions.
1. Lay out all parts and check that you have the correct quantities as listed in the components list. If you are missing any part do
not assemble the pool, contact Coleman Customer Service.
2. Spread out the pool and make sure the pool is right side up, let it sit exposed to direct sunlight for 1 or more hours so that the
pool is more flexible during setup.
3. Place the pool near an adequate drainage system to deal with overflow water and ensure the pool's inlet A and outlet B are
correctly positioned to allow your filter pump to connect to a power source. Note: Do not use extension power cords to power
your pump.
ATTENTION: Do not drag the pool on the ground. This can damage the pool.
4. Insert the stopper plugs into inlet A and outlet B on the wall from the inside of the pool(See Fig.1).
NOTE: For 4.88m x 1.22m (16'x48"), 5.49 m x 1.22 m (18' x 48"), 6.71m x 1.32m (22' x 52"), 7.93m x 1.32m (26'x52") pools,
please refer to the connection valve installation on following page.
5. Insert top rail into the pole pockets at the top of the pool. (See Fig.2) Starting at any location, but always working in the same
direction.
6. Once the top rail is centered, connect top rail with T-Connector at each of corner, ensure the spring-loaded pins snap into the
pre-drilled holes. (See Fig.3)
7. Repeat steps 5 and 6 until all top rails are connected with T-Connectors and the top frame is set up. For ease of assembly
slightly raise the last T-Connector and top rail to an inverted v shape and insert into the last T-Connectors. Slowly lower until
fully connected taking care not to pinch your fingers. (See Fig.4)
8. Put all vertical pool legs inside the bottom rope and the pool wall band. Connect vertical pool leg into the bottom of the
T-Connector. Make sure the vertical pool leg has the spring loaded pins at the top when connecting the T-Connector.
(See Fig.5)
9. Attach all footings to the bottom of the vertical pool legs. (See Fig.6)
10. Tighten the rope at the bottom of the pool until the legs are straight. (See Fig.7)
11. Check all rails, pool legs and connectors to ensure they are in right position and are firmly jointed. (See Fig.8)
12. Ensure drain valve is firmly closed. Smooth out the bottom.
13. Put 1" to 2" (2.5cm to 5cm) water in the pool to cover the floor. Once pool floor is slightly covered, gently smooth out all
wrinkles. Start in the center of the pool and work your way clockwise to the outside.
3
S-S-002195

Publicidad

loading