Product Installation; Before Installation - brondell SouthSpa LH-20 Manual De Usario

PRODUCT INSTALLATION

BEFORE INSTALLATION

IMPORTANT
Please be advised that the provided
T-Valve should be installed at the Fill
Valve under the toilet tank, and NOT
at the cold water supply coming from
the wall .
If you do not have access to the Fill
Valve under the toilet tank, contact
Brondell Customer Service at
888 .542 .3355 . We may be able to
guide you through the process .
Check the size of the hot water supply connection (most likely under the sink/wash
basin) . This needs to be a 3/8" connection for our T-valve to install .
Note: if the connection is a 1/2" connection, you will need to purchase the following
reducing adapter available online and at many plumbing hardware stores: Reducing
Adapter, 1/2" Female NPT x 3/8" Male Compression.
Check Water Supply Line
Check the water supply line that connects the toilet tank fill valve to the water
shutoff valve at the wall . If it is a rigid pipe, you will need to purchase a flexible
water supply hose to replace it before installing the SouthSpa . The length of the
hose may vary, and the top connection size should be 7/8" Ballcock to connect to
the T-valve that you will install under the toilet tank, and the bottom connection will
vary (most common are 3/8" and 1/2" female compression) .
5