brondell SouthSpa LH-20 Manual De Usario página 9

CONNECTING THE COLD WATER SUPPLY (cont.)
4 . Connect Bidet Hose to T-Valve
a . Connect one end of the braided metal bidet
hose to the remaining open side of the
installed T-valve .
IMPORTANT
If you are only connecting the cold water supply,
you must install the Hot Water Supply Cap
(provided - see Page 3) over the hot water
connection on your SouthSpa (see diagram) .
Failure to connect or cap the hot water supply will
result in leaking during use .
After installing hot water cap, proceed to "Installing
the Bidet Attachment" on Page 10 .
If you wish to also connect your hot water supply,
then proceed to "Connecting the Hot Water Supply"
on Page 8 .
Step 4a
7