Descargar Imprimir esta página

Miele 10717771 Instrucciones De Montaje página 7

Publicidad

M.-Nr. 10717771
A
Connect plug N1Q_ST11A to ST11 Pin 1-2 on the module, see Fig. 3.
A
Connect coding plug 3-5 to ST3 on the module, see Fig. 3.
The power (L, N) and control (bus) wiring harnesses must be laid separately in order to avoid interference in the
control circuit (electromagnetic compatibility).
Excess cable should be gathered so that current flows in opposite directions and tied to avoid any antenna effect.
A
Lay and connect the "1N1-16, 2N1-16 L, N" wiring harness; see Fig. 3.
A
Lay and connect the "1N1-16, 2N1-16 bus" wiring harness; see Fig. 3.
A
Connect the new terminal strips with brown connection wires to the existing terminal strips in accordance with the
wiring diagram, see Fig. 3.
A
Connect the dispenser pumps in accordance with the wiring diagram.
A
Install water recycling in accordance with the Installation instructions.
A
Connect water recycling in accordance with the wiring diagram.
A
Fit the machine lid.
A
Log the module on, see Service mode in the model-specific TSD.
A
Log water recycling on, see Service mode in the model-specific TSD.
A
Calibrate the dispenser pumps, see Supervisor level in the Operating instructions for the machine.
en
cs
Montážní návod modulu 3 pro dávkování tekutých prostředků 7-11 a rekuperaci vody
Důvod: Modul je nutný pro připojení dávkovacích čerpadel pro dávkování tekutých prostředků a rekuperace vody
k pračce.
Obsažené díly
Počet
č. m.
Název
1
elektronika EZL 235, modul 3
4
příchytka desky
1
kódovací zástrčka MFM 3-5
1
kódovací zástrčka WRG 1
1
kódovací zástrčka MFM 53X
1
zástrčka N1Q-ST11A
1
kabelová forma 1N1-16, 2N1-16 L, N
1
kabelová forma 1N1-16, 2N1-16 Bus
3
spojovací vodič černý 0,75 x 90
1
4pólová zástrčka, přírodní
1
4pólová zástrčka, červená
1
6pólová zástrčka, modrá
1
7pólová zástrčka, zelená
1
svorkovnice 3X3-4, oranžová / šedá
1
svorkovnice 4X3-4, modrá / zelená / žlutá
1
příslušenství dávkování tekutých prostředků
1
přídržný úhelník pro elektroniku
2
upevňovací plech pro přídržný úhelník pro elektroniku
4
šrouby s čočkovou hlavou CEM 6 x 12
1
schéma zapojení
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
7 von 28
24.11.2017

Publicidad

loading