Typical Installation - Powermate Px P010-0037SP Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Key Description

Air hose

In-line Filter

Tee Fitting

Before Spraying

1. As a standard practice, drain water from the air

compressor tank and air lines prior to use each day

(reference your compressor operators manual for

detailed instructions). NOTE: Failure to install

appropriate water/oil removal equipment may

result in damage to the spray gun or workpiece

(see Figure 1).

2. Install the regulator onto the air inlet port of the tool

then install a 1/4" NPT female connector (included

in accessory kit) onto the air inlet port of the

regulator. (see Figure 2). Note: Use Teflon® Tape

on all threaded connections.

3. Attach air supply line to 1/4 NPT female connector

plug.

4. Start the compressor and set the regulator to 40-50

PSI. NOTE: Be sure there is sufficient hose

connected between the gun and air supply to

comfortably reach the work surface.

This spray gun is designed to

operate best at pressures between 25-50 PSI.

Never attempt to operate this spray gun at

pressures in excess of 50 PSI.

5. Mix material according to the manufacutrer's

instructions, adding thinner if needed. Mixture should be smooth and easily pourable. Lumps or foreign objects

should be removed by straining through a suitable paint filter or cheesecloth.

6. Attach the paint cup to the gun.

7. Remove the paint cup cover and fill the cup about 3/4 full with paint then replace the cover. NOTE: If using

the spray gun for the first time, fill the paint cup with thinner and spray

into a grounded metal waste container to flush the gun and cup of any

impurities that may have accumulated during assembly and shipping.

Spraying Instructions

1. Begin spraying. Hold the gun about 6 to 9 inches from the work surface

and while moving the gun from side to side, depress the trigger to begin

applying material. To avoid blobs, runs and lap marks, keep the gun in

motion at all times before, after and while the trigger is depressed (see

Figure 3). When spraying from the left to right, use the vertical pattern and

when spraying from the top to bottom, use the horizontal pattern (see Figure

4) . Practice painting on a piece of scrap material or cardboard until the test

coating results are acceptable, making adjustments as follows:

a. Pattern control knob (see Figure 2) - for a full pattern, turn the knob in a

counterclockwise direction and for a round pattern, turn the knob clockwise.

This knob is used to create the proper pattern of paint as it is sprayed from

the spray gun.