Typical Installation - Powermate Px P024-0303SP Manual De Instrucciones

Llave de trinquete de 3/8” sin reacción

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Key

Description

Air hose

In-line Filter

Tee Fitting

To begin using the tool:

As a standard practice, drain water from the air

compressor tank and air lines prior to use each day

(reference your compressor operators manual for

detailed instructions).

Install a 1/4" NPT male connector (not included) into

the air inlet port on the tool (see Figure 2). Note:

Use Teflon® Tape on all threaded connections.

Turn on the air compressor and allow it to build up

pressure.

Adjust the air compressor's regulator or the supply

line regulator to 90 PSI.

Attach the desired 3/8" square drive socket (use 3/8" deep sockets and only use extensions when

needed).

Always use impact-type sockets and extensions that are designed for ratchet

wrenches. Hand tool sockets will shatter and potentially cause personal injury and/or

property damage.

Connect the tool to the air hose quick coupler. NOTE: It is recommended that a whip hose with a swivel

(P012-0079SP - not included) be used to prevent twisting, kinking and excessive wear to the air hose

(ref. item "F" in figure 1 for recommended connections).

Always grip the air ratchet well to avoid the chance of it being wrenched from your

grasp or the possibility of it throwing you off balance.

Select the tool rotation direction. Push in and turn the forward/reverse button to the right (clockwise) for

forward or the left (counterclockwise) for reverse.

To remove a fastener, push in and turn the forward/reverse button to "R" (counterclockwise). Grip the

wrench with your hand and place it on the fastener to be loosened. Break the fastener loose by hand,

then gently squeeze the trigger to completely remove it. Release the trigger to stop the tool.

NOTE: Soak rusted nuts in penetrating oil and break the rust seal before removing with the air

ratchet wrench. If the nut does not start to move in three to five seconds, use a larger size air

ratchet wrench. Do not use the air ratchet wrench beyond the rated capacity, as this will

drastically reduce the tool life.

To tighten a fastener, push in and turn the forward/reverse button to "F" (clockwise). Start the

fastener by hand then grip the ratchet wrench with your hand and place it on the fastener to be

tightened. Gently squeeze the trigger to tighten down the fastener. Drive the fastener until the ratchet

stalls, release the trigger to stop the tool, and then tighten further by operating the air ratchet wrench in

the same manner as you would operate a manually operated ratchet wrench.

To adjust the speed of the tool, turn the speed control screw to the left (counterclockwise) to decrease