Setting - Camera; Setting - Monitor - REV JY-249 Instrucciones De Instalacion Y Uso

4. Connect the mains power unit with the camera (16)
(Pic. 3-5).
5. Put the camera on the installation ring. To engage the
camera with the installation ring, you must rotate the camera
in the clockwise direction (Pic. 6).

Setting - camera

Channel selection on the camera (15):
The audio/video monitoring system has four different channels.
With these, 4 cameras can be displayed on one monitor. The
desired channel for this camera is selected with the help of the
channel selection switch on the bottom side of the camera
(see sketch).
A B C D
Each channel may only be assigned to one camera.

Setting - monitor

Channel selection on the monitor (3):
Channels are selected by pressing the channel selection
button (3). The preset channel is displayed via a light diode
(see sketch). This is how the camera that shall be displayed is
determined. The selection A-D permanently shows the
respective image from the selected camera. The selection
"AUTO" shows the image from each channel for 4 sec and
then changes to the next one. The channels not occupied with
cameras are also displayed.
A
Channel
19
Four channels can be selected
e.g. Channel B is set.
e.g. Channel B /
second LED lights
B C D AUTO