Enclosure Installation; Preparation; Unpacking; Ground Connection - Tripp-Lite CS16AC El Manual Del Propietario

4. Enclosure Installation

Caution! Read All Instructions and Warnings Before Installation!
Warning: Rack enclosures can be extremely heavy. Do not attempt to unpack, move or install the enclosure without assistance.
Use extreme caution when handling the enclosure and be sure to follow all handling and installation instructions. Do not
attempt to install equipment without first stabilizing the enclosure.

4.1 Preparation

The enclosure must only be mounted to wall surfaces that can safely support the combined weight of the enclosure, equipment and all attached
hardware and components, or floor areas capable of handling the full enclosure load and contents as well as any other enclosures and/or equipment
that will be installed nearby. Before unpacking the enclosure, you should transport the shipping container close to the final installation location to
minimize the distance you will need to move the unit after the protective packaging has been removed. If you plan to store the enclosure for an
extended period before installation, follow the instructions in the Storage and Service section.
For wall mounting, you will need:
• Level
• Phillips-head screwdriver
• Appropriate tools for wall mounting

4.2 Unpacking

Note: The enclosure should be moved close to its installation location inside its shipping container before it is unpacked. For mobile applications, use the CSHANDLEKIT
caster and handle accessory kit.
1 Open box and remove the corner protectors. Upon unpacking, examine the inside of the cabinet for any additional packing material. Make sure to
remove all packing materials from the interior and exterior of the unit. Save all packing materials for later use unless you are certain they will not
be required. Packing materials are recyclable.
With one person on each side, carefully lift the enclosure out of the box and place on a firm, level surface.
2
3 Examine the enclosure for any damage or loose parts. Confirm all parts are present. If anything is missing or damaged, contact Tripp Lite for
assistance. Do not attempt to use the enclosure if it has been damaged.
Warning: Never attempt to lift or install without adequate help.

4.3 Ground Connection

All parts of the enclosure are grounded to the
frame of the enclosure. Connect your facility's
earth ground connection to the provided ground
stud using an 8 AWG (3.264 mm) wire.
A
Warning: Attach each enclosure to earth
ground separately. Do not use the
enclosure without an earth ground
connection.

4.4 Power Requirements

The charging station should be plugged into an AC outlet with a dedicated circuit. An AC outlet with a 20-amp circuit is preferred for powering the
charging station. The AC outlet used to power the charging station should not be shared with other electronics. The total wattage of the charging
station and all connected components should not exceed 720 watts (CS16AC/CS16ACW model) or 1440 watts (CS32AC/CS32ACW model).
You also need the following hardware:
• Appropriate hardware for wall mounting (not included)
Use at least two people to unpack the enclosure.
Do not try lifting the enclosure alone.
A
EARTH
GROUND
CS16AC(W)
4
EARTH
GROUND
A
CS32AC(W)