Safety Rules 1 - HAMPTON BAY Carriage House II Manual Del Propietário

To reduce the risk of electric shock, insure electricity
1.
has been turned off at the circuit breaker or fuse box
before beginning.
All wiring must be in accordance with the National
2.
Electrical Code ANSI/NFPA 70-1999 and local electrical
codes. Electrical installation should be performed by a
qualified licensed electrician.
WARNING: To reduce the risk of fire or electric shock, do
3.
not use this fan with any solid-state speed control device.
The outlet box and support structure must be securely
4.
mounted and capable of reliably supporting a minimum of
35 pounds. Use only UL Listed outlet boxes marked "FOR
FAN SUPPORT."
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL
INJURY, MOUNT FAN TO OUTLET BOX MARKED "ACCEPTABLE FOR
FAN SUPPORT" WITH THE SCREWS PROVIDED WITH THE OUTLET
BOX.
The fan must be mounted with a minimum of 7 feet
5.
clearance from the trailing edge of the blades to the floor.
Do not operate reversing switch while fan blades are in mo-
6.
tion. Fan must be turned off and blades stopped before re-
versing blade direction.
Avoid placing objects in path of the blades.
7.
To avoid personal injury or damage to the fan and
8.
other items, be cautious when working around or
cleaning the fan.
READ AND SAVE THESE INSTRUCTIONS
Do not use water or detergents when cleaning the fan or fan
9.
blades. A dry dust cloth or lightly dampened cloth will be
suitable for most cleaning.
After making electrical connections, spliced conductors
10.
should be turned upward and pushed carefully up into
outlet box. The wires should be spread apart with the
grounded conductor
conductor on one side of the outlet box and ungrounded con-
ductor on the other side of the outlet box.
Electrical diagrams are for reference only. Light kits that are
11.
not packed with the fan must be UL Listed and marked suit-
able for use with the model fan you are installing. Switches
must be UL General Use Switches. Refer to the instructions
packaged with the light kits and switches for proper assembly.
All set screws must be checked and retightened where neces-
12.
sary before installation.
TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND THE
BLADE BRACKETS (ALSO REFERRED TO AS "FLANGES") DURING
ASSEMBLY OR AFTER INSTALLATION. DO NOT INSERT OBJECTS IN
THE PATH OF THE BLADES.
and the equipment-grounding

Safety Rules 1.