HAMPTON BAY Carriage House II Manual Del Propietário página 9

in Figure 11. Rotate the fan until the next
blade is positioned for measurement. Repeat
for each blade. Measurement deviations
should be within 1/8". Run the fan for 10
minutes.
3. Use the enclosed Bladed Balancing Kit if
the blade wobble is still noticeable.
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT FOREIGN
OBJECTS BETWEEN ROTATING BLADES.
Attaching the Light Kit
REMEMBER to disconnect the power.
1. Remove the three mounting screws on the
black bracket below the motor.
2. Engage the connector of the switch cup/
light kit assembly with the motor connector
(Figure 12). The two connectors are keyed
and must be matted correctly before they
can be engaged. Make sure the connector
latch closes properly.
3. Position the switch cup/light kit assembly
on the black switch cup plate and align the
three holes in the plate. Make sure the notch
in the switch cup plate clears the reversing
switch in the switch cup/light kit assembly.
Re-install the three mounting screws to se-
cure the switch cup/light kit assembly.
4. To install the glass shade, back the three
knurled screws out until the glass shade
neck slips into the glass holder (Figure
12)". Then finger tighten the screws un-
til three screws touch the neck with ap-
proximate equal projection on the outside.
Figure 11
NOTE: Periodically check the tightness
of the knurled screws. Fan operation may
loosen these screws.
5. With the power off, insert the light bulbs
into the light sockets. Use 60w max bulbs
(provided).
If you need an extra switch cup
(or cover) for the non-light option,
please call 1-800-283-6513
(M-F 9:00am to 4:30pm EST).
(4)
Figure 12
7.