Suspendre Le Ventilateur - Hinkley Swell Manual Del Usuario

SUSPENDRE LE VENTILATEUR

Remove ball from downrod by loosening set screw in the side of the
1
ball. Slide ball down and remove ball pin; remove ball. (Fig. 1)
Carefully support fan body (motor) in its styrofoam packing with the
2
mounting collar (where the wires come out) facing upward.
3 Loosen the two security set screws and remove the downrod pin
and retaining clip from the coupling on top of the motor assembly.
(Fig. 2)
Carefully feed the electrical lead wires and safety cable from the fan
4
through the downrod. Thread downrod into coupler until holes
align. Insert downrod pin through holes in mounting collar and
downrod; clip cotter pin through small hole in end of downrod pin
to hold downrod in place.
Tighten security set screws against downrod using a large at blade
5
screwdriver to ensure a tight t against downrod. Tighten nuts
against mounting collar.
06
| hinkley.com
Goupille transversale
Balle suspendue
Vis de réglage
Fig. 1
Goupille de tige
de descente
Collier de montage
Goupille
Haut du corps
du ventilateur
Fig. 2
Tige de suspension
Vis de sécurité
Goupille de tige
descendante