Temperature Units; Delay Start - GE Profile Advantium PSA1200 Manual Del Usuario

Turntable
Use this feature to keep the turntable from
turning when using a dish is too large to
On/OFF
rotate in the cavity.
TURNTABLE ON/OFF is not a permanent
setting.
Press the SETTINGS pad, turn the dial to
select TURNTABLE ON/OFF and press the dial
to enter. Turn the dial to select TURNTABLE
ON or TURNTABLE OFF, press the dial to
enter.
Auto Night
Use this feature to set the surface light to
come on and go off at a certain time.
Light
1. Press the SETTINGS pad, turn the dial to
2. Select SET ON TIME and press the dial to
3. Turn the dial to set on time hour and
To disable the Auto Night Light feature, press
the SETTINGS pad, turn the dial to select
AUTO NIGHT LIGHT and press the dial to
enter. Turn the dial to select DEACTIVATE and
press the dial to enter.
Temperature
To change temperature units, press the
SETTINGS pad and select TEMPERATURE
Units
UNITS. Turn the dial to select F or C and press
the dial to enter.

Delay Start

Use this feature to delay when the oven will
start cooking in CONV BAKE, COOK BY TIME,
COOK BY TIME 1&2, DEFROST BY TIME, or
DEFROST BY WEIGHT.
1. Press the COOKING OPTIONS pad.
2. Turn the dial to select DELAY START and
30
select AUTO NIGHT LIGHT and press the
dial to enter.
enter.
minutes, press the dial to enter. Turn the
dial to set off time hour and minutes, press
the dial to enter. Note: Setting the hours
sets AM/PM.
press the dial to enter.
Other Advantium Features
Advantium Oven
Note:
• The turntable will not turn off in Speedcook,
Broil, Toast, or Microwave Sensor modes.
• A cooking cycle must be started within 5
minutes of turning the turnable off, or the
turntable will reset to the on setting.
• The turntable will also remain off for
cooking cycles started within 5 minutes of
the end of any cooking cycle for which the
turntable was off.
To check the Auto Night Light on and off
times, press the SETTINGS pad, turn the dial
to select AUTO NIGHT LIGHT and press the
dial to enter. Turn the dial to select REVIEW
ON/OFF TIMES and press the dial to enter.
The display will show the on and off time for
the Auto Night light.
Note:
• Auto Night Light will turn on the surface
light to the night setting, when the clock
time matches the Auto Night Light on time,
even if the surface light is on the bright
setting.
• Auto Night Light will always turn the
surface light off when the clock time
matches the Auto Night Light off time if the
surface light is turned on.
3. Turn the dial to set the start time hour
and minutes, press the dial to enter.
NOTE: Setting the hours sets AM/PM.
4. Set the cooking mode.
The oven will start the programmed cooking
mode when the clock time and the delay
start time are the same.